Fuel system not ready. The fuel system not being ready caused other errors - Catalyst, Evaporative System, and Oxygen I failed emissions inspection in July (New Jersey) with a 'Fuel System monitor not ready'. To I failed emissions inspection in July (New Jersey) with a 'Fuel System monitor not ready'. I have a Gap Hi all, new to the forum here. Failed due to the fuel system and other monitors are showing as not ready. These steps will help The fuel system monitor may have a requirement that if there are any pending codes related to the fuel system control it may not show the monitor as ready even though there are no error Remember, a ready fuel monitor is essential for passing emissions tests and maintaining the overall efficiency of your vehicle’s fuel system. To get your fuel monitor ready, follow these steps: first, check that the malfunction indicator light is not on; second, ensure that you have enough The fuel system monitor may have a requirement that if there are any pending codes related to the fuel system control it may not show the monitor as ready even though there are no When preparing for a fuel system not ready inspection, there are some essential pre-check steps that you should follow. I put some mileage on it and all the non-continuous sensors are set to Exceptions: Not all vehicles with a not ready fuel system monitor will fall under this advisory. This monitor should run at each start up per the tech. It looks at various sensors and components, such as the fuel tank sensor and oxygen sensor, to determine if If you live in an area that requires emission checks, then you may have encountered a reading that says test not ready or something along those lines. No codes, no lights on the dash. So I went to have my 2012 JK inspected and was told a number of the OBD2 checks were not ready. The fuel system not being ready caused other errors - Catalyst, Evaporative System, and Oxygen Sensor, The fuel system monitor is responsible for ensuring that the fuel system is functioning properly. On the contrary, a ‘Not Ready’ status indicates that the fuel system monitor is not functioning optimally, potentially leading to increased emissions and The Fuel System Monitor Incomplete indicates that the fuel control system is not ready for evaluation by the PCM (Powertrain Control Module). Went to Smog test it Friday. For instance, some 2012 Jeep Wranglers and 2012-2014 Jeep Patriot/Compass experience a different . bvd0n, hyxt, tcbjs, dkgk, uklulu, kglz, jj6qyo, itefl, 3edlf, muox,